Installing RAS in NT

From XMission Wiki

1. Click Start, go to Settings, and select Control Panel.
2. Double-click on Network.
3. Select the Services tab.
4. In the Network Services box, check for Remote Access.

   Note: If you DO see Remote Access in the Network Services box, highlight it, click Properties, and jump to step 9.

5. 
6. Click Add.
7. Scroll down to Remote Access Service and highlight it.
8. Click OK.
9. 
10. Insert the Windows NT disk and click Continue.
11. Select your modem from the menu.
12. Click OK.
13. 
14. Click Configure.
15. 
16. Select Dial out only.
17. Click OK.
18. 
19. Click Network.
20. Make sure TCP/IP is the only protocol selected.
21. Click OK.
22. 
23. Click Continue.
24. Click Close.

    Note: Windows NT will update your Bindings Configuration, and then prompt you to reboot your computer. You must reboot.

25. Click Yes to reboot your computer.