Difference between revisions of "DSL Actiontec 1520/1524 Setup"

From XMission Wiki
Jump to: navigation, search
 
(One intermediate revision by the same user not shown)
Line 1: Line 1:
 +
{{archived}}
 +
 
#Launch the Autorun program from the install CD (if it does not AutoRun).
 
#Launch the Autorun program from the install CD (if it does not AutoRun).
 
#Follow the instructions on the screen untill it asks you to select an ISP protocol.
 
#Follow the instructions on the screen untill it asks you to select an ISP protocol.
Line 17: Line 19:
 
If you purchased a multiple IP block, you may configure it now
 
If you purchased a multiple IP block, you may configure it now
  
−
[[Category:Troubleshooting|DSL]]
+
 
−
[[Category:DSL Configuration|Actiontec 1520/1524 Setup]]
+
[[Category:DSL Troubleshooting|Actiontec 1520/1524 Setup]]
 
[[Category:DSL]]
 
[[Category:DSL]]
 
[[Category:PPPoA]]
 
[[Category:PPPoA]]

Latest revision as of 13:46, 6 June 2019

Archives.png


  1. Launch the Autorun program from the install CD (if it does not AutoRun).
  2. Follow the instructions on the screen untill it asks you to select an ISP protocol.
  3. Select PPPoA under Please select ISP protocol.
  4. Click Next.
    Bdy-prot.jpg
  5. Type your XMission username under User ID.
  6. Type your XMission password under Password.
  7. Click Next.
    Bdy-act.jpg
  8. Select Dynamic IP (DHCP).
  9. Click Next.
    Bdy-ip.jpg
  10. Click Finish.
    Bdy-done.jpg
Note: At this point the configuration for your Actiontec is complete. Shortly after the Internet light on your Actiontec becomes solid you should be able to access the Internet.

Remember, if you ever change your XMission password, you'll need to update your password in the Actiontec] as well. If you purchased a multiple IP block, you may configure it now

Retrieved from "http://wiki.xmission.com/index.php?title=DSL_Actiontec_1520/1524_Setup&oldid=9731"