Using Hyperterminal to Connect to Your Cisco 675/678: Difference between revisions
Jump to navigation
Jump to search
New page: Using Hyperterminal to Connect to Your Cisco 675/678 #Connect the serial end (metal) of your management cable to Com port 1 on your computer and the other end (plastic) into the manageme... |
mNo edit summary |
||
| Line 1: | Line 1: | ||
{{Archived}} | |||
Using Hyperterminal to Connect to Your Cisco 675/678 | Using Hyperterminal to Connect to Your Cisco 675/678 | ||
| Line 14: | Line 15: | ||
<div class="messagebox metadata">'''Note''': If you don't get a <span class="button">password:</span> prompt, to check to be sure the management cable is plugged into Com1. Disconnect and reconnect again.</div> | <div class="messagebox metadata">'''Note''': If you don't get a <span class="button">password:</span> prompt, to check to be sure the management cable is plugged into Com1. Disconnect and reconnect again.</div> | ||
{{Footer}} | |||
[[Category:DSL]] | [[Category:DSL]] | ||
[[Category:Archive]] | |||
Revision as of 20:06, 25 February 2008
Using Hyperterminal to Connect to Your Cisco 675/678
- Connect the serial end (metal) of your management cable to Com port 1 on your computer and the other end (plastic) into the management port of your Cisco router.
- Click , go to , , , and select .
- Double-click on .
- Enter any name for the connection you'd like and choose an icon.
- Click .
- In the field, choose .
- Click .
- Change the to 38400.
- Change the to .
- Click .
- Hit the enter key and you should get a prompt.