Difference between revisions of "Using Hyperterminal to Connect to Your Cisco 675/678"

Latest revision as of 12:49, 6 June 2019

Connect the serial end (metal) of your management cable to Com port 1 on your computer and the other end (plastic) into the management port of your Cisco router.
Click Start, go to Programs, Accessories, Communications, and select Hyperterminal.
Double-click on Hyperterm.
Enter any name for the connection you'd like and choose an icon.
Click OK.
In the Connect using: field, choose Direct to Com1.
Click OK.
Change the Bits per second: to 38400.
Change the Flow control: to None.
Click OK.
Hit the enter key and you should get a password: prompt.

Note: If you don't get a password: prompt, to check to be sure the management cable is plugged into Com1. Disconnect and reconnect again.

@@ Line 1: / Line 1: @@
-{{Archived}}
+{{archived}}
-Using Hyperterminal to Connect to Your Cisco 675/678
 #Connect the serial end (metal) of your management cable to  Com port 1 on your computer and the other end (plastic) into the management  port of your Cisco router.
 #Click <span class="button">Start</span>, go to <span class="button">Programs</span>, <span class="button">Accessories</span>, <span class="button">Communications</span>,  and select <span class="button">Hyperterminal</span>.
-#Double-click on <span class="button">Hypertrm</span>.
+#Double-click on <span class="button">Hyperterm</span>.
 #Enter any name for the connection you'd like and choose an icon.
 #Click <span class="button">OK</span>.
@@ Line 16: / Line 15: @@
-{{Footer}}
+[[Category:DSL Troubleshooting|Hyperterm]]
-[[Category:DSL|Hyberterm]]
+[[Category:DSL]]
-[[Category:DSL Archives|Hyperterm]]
+[[Category:PPPoA]]
+[[Category:DSL|Hyperterm|Terminal|Cisco]]