Difference between revisions of "Using Hyperterminal to Connect to Your Cisco 675/678"

From XMission Wiki
Jump to: navigation, search
m
 
(6 intermediate revisions by 4 users not shown)
Line 1: Line 1:
−
{{Archived}}
+
{{archived}}
−
Using Hyperterminal to Connect to Your Cisco 675/678
 
  
 
#Connect the serial end (metal) of your management cable to  Com port 1 on your computer and the other end (plastic) into the management  port of your Cisco router.
 
#Connect the serial end (metal) of your management cable to  Com port 1 on your computer and the other end (plastic) into the management  port of your Cisco router.
 
#Click <span class="button">Start</span>, go to <span class="button">Programs</span>, <span class="button">Accessories</span>, <span class="button">Communications</span>,  and select <span class="button">Hyperterminal</span>.
 
#Click <span class="button">Start</span>, go to <span class="button">Programs</span>, <span class="button">Accessories</span>, <span class="button">Communications</span>,  and select <span class="button">Hyperterminal</span>.
−
#Double-click on <span class="button">Hypertrm</span>.
+
#Double-click on <span class="button">Hyperterm</span>.
 
#Enter any name for the connection you'd like and choose an icon.
 
#Enter any name for the connection you'd like and choose an icon.
 
#Click <span class="button">OK</span>.
 
#Click <span class="button">OK</span>.
Line 16: Line 15:
  
  
−
{{Footer}}
+
[[Category:DSL Troubleshooting|Hyperterm]]
 
[[Category:DSL]]
 
[[Category:DSL]]
−
[[Category:Archive]]
+
[[Category:PPPoA]]
 +
 
 +
[[Category:DSL|Hyperterm|Terminal|Cisco]]

Latest revision as of 12:49, 6 June 2019

Archives.png


  1. Connect the serial end (metal) of your management cable to Com port 1 on your computer and the other end (plastic) into the management port of your Cisco router.
  2. Click Start, go to Programs, Accessories, Communications, and select Hyperterminal.
  3. Double-click on Hyperterm.
  4. Enter any name for the connection you'd like and choose an icon.
  5. Click OK.
  6. In the Connect using: field, choose Direct to Com1.
  7. Click OK.
  8. Change the Bits per second: to 38400.
  9. Change the Flow control: to None.
  10. Click OK.
  11. Hit the enter key and you should get a password: prompt.
Note: If you don't get a password: prompt, to check to be sure the management cable is plugged into Com1. Disconnect and reconnect again.
Retrieved from "http://wiki.xmission.com/index.php?title=Using_Hyperterminal_to_Connect_to_Your_Cisco_675/678&oldid=9746"