Difference between revisions of "Using Hyperterminal to Connect to Your Cisco 675/678"
From XMission Wiki
m |
|||
| Line 1: | Line 1: | ||
| − | |||
| − | |||
| − | |||
#Connect the serial end (metal) of your management cable to Com port 1 on your computer and the other end (plastic) into the management port of your Cisco router. | #Connect the serial end (metal) of your management cable to Com port 1 on your computer and the other end (plastic) into the management port of your Cisco router. | ||
#Click <span class="button">Start</span>, go to <span class="button">Programs</span>, <span class="button">Accessories</span>, <span class="button">Communications</span>, and select <span class="button">Hyperterminal</span>. | #Click <span class="button">Start</span>, go to <span class="button">Programs</span>, <span class="button">Accessories</span>, <span class="button">Communications</span>, and select <span class="button">Hyperterminal</span>. | ||
| − | #Double-click on <span class="button"> | + | #Double-click on <span class="button">Hyperterm</span>. |
#Enter any name for the connection you'd like and choose an icon. | #Enter any name for the connection you'd like and choose an icon. | ||
#Click <span class="button">OK</span>. | #Click <span class="button">OK</span>. | ||
| Line 14: | Line 11: | ||
#Hit the enter key and you should get a <span class="button">password:</span> prompt. | #Hit the enter key and you should get a <span class="button">password:</span> prompt. | ||
<div class="messagebox metadata">'''Note''': If you don't get a <span class="button">password:</span> prompt, to check to be sure the management cable is plugged into Com1. Disconnect and reconnect again.</div> | <div class="messagebox metadata">'''Note''': If you don't get a <span class="button">password:</span> prompt, to check to be sure the management cable is plugged into Com1. Disconnect and reconnect again.</div> | ||
| − | |||
{{Footer}} | {{Footer}} | ||
| − | [[Category:DSL| | + | [[Category:DSL|Hyperterm|Terminal|Cisco]] |
| − | |||
Revision as of 16:25, 12 February 2009
- Connect the serial end (metal) of your management cable to Com port 1 on your computer and the other end (plastic) into the management port of your Cisco router.
- Click , go to , , , and select .
- Double-click on .
- Enter any name for the connection you'd like and choose an icon.
- Click .
- In the field, choose .
- Click .
- Change the to 38400.
- Change the to .
- Click .
- Hit the enter key and you should get a prompt.
