Difference between revisions of "Using Hyperterminal to Connect to Your Cisco 675/678"

From XMission Wiki
Jump to: navigation, search
Line 12: Line 12:
 
<div class="messagebox metadata">'''Note''': If you don't get a <span class="button">password:</span> prompt, to check to be sure the  management cable is plugged into Com1. Disconnect and reconnect again.</div>
 
<div class="messagebox metadata">'''Note''': If you don't get a <span class="button">password:</span> prompt, to check to be sure the  management cable is plugged into Com1. Disconnect and reconnect again.</div>
  
−
[[Category:Troubleshooting|DSL|Cisco 675/678]]
+
 
−
[[Category:DSL Configuration|Hyperterm]]
+
[[Category:DSL Troubleshooting|Hyperterm]]
 
[[Category:DSL]]
 
[[Category:DSL]]
 
[[Category:PPPoA]]
 
[[Category:PPPoA]]
  
 
[[Category:DSL|Hyperterm|Terminal|Cisco]]
 
[[Category:DSL|Hyperterm|Terminal|Cisco]]

Revision as of 14:34, 15 January 2014

  1. Connect the serial end (metal) of your management cable to Com port 1 on your computer and the other end (plastic) into the management port of your Cisco router.
  2. Click Start, go to Programs, Accessories, Communications, and select Hyperterminal.
  3. Double-click on Hyperterm.
  4. Enter any name for the connection you'd like and choose an icon.
  5. Click OK.
  6. In the Connect using: field, choose Direct to Com1.
  7. Click OK.
  8. Change the Bits per second: to 38400.
  9. Change the Flow control: to None.
  10. Click OK.
  11. Hit the enter key and you should get a password: prompt.
Note: If you don't get a password: prompt, to check to be sure the management cable is plugged into Com1. Disconnect and reconnect again.
Retrieved from "http://wiki.xmission.com/index.php?title=Using_Hyperterminal_to_Connect_to_Your_Cisco_675/678&oldid=5828"