Difference between revisions of "Installing RAS in NT"

Revision as of 14:45, 14 March 2008

1. Click Start, go to Settings, and select Control Panel.
2. Double-click on Network.
3. Select the Services tab.
4. In the Network Services box, check for Remote Access.

   Note: If you DO see Remote Access in the Network Services box, highlight it, click Properties, and jump to step 9.

   http://www.xmission.com/help/screenshots/winnt/winnt09.gif

5. Click Add.
6. Scroll down to Remote Access Service and highlight it.
7. Click OK.

   http://www.xmission.com/help/screenshots/winnt/winnt10.gif

8. Insert the Windows NT disk and click Continue.
9. Select your modem from the menu.
10. Click OK.

    http://www.xmission.com/help/screenshots/winnt/winnt11.gif

11. Click Configure.

    http://www.xmission.com/help/screenshots/winnt/winnt12.gif

12. Select Dial out only.
13. Click OK.

    http://www.xmission.com/help/screenshots/winnt/winnt13.gif

14. Click Network.
15. Make sure TCP/IP is the only protocol selected.
16. Click OK.

    http://www.xmission.com/help/screenshots/winnt/winnt14.gif

17. Click Continue.
18. Click Close.

    Note: Windows NT will update your Bindings Configuration, and then prompt you to reboot your computer. You must reboot.

19. Click Yes to reboot your computer.