Difference between revisions of "Cisco 678 Single"

Revision as of 14:27, 15 January 2014

Connect to your Cisco 600 series through Hyperterm,

Hit enter until you see the following cbos prompt. Then type the following commands.

cbos>enable Password:(Hit enter here)

cbos#set nvram erase

cbos#write

cbos#reboot

Hello! Expanding CBOS image... CBOS [version]

Hit enter to get the cbos prompt

cbos>enable Password:Hit enter

cbos#set ppp wan0-0 ipcp 0.0.0.0

cbos#set ppp wan0-0 dns 0.0.0.0

cbos#set ppp wan0-0 login (your login name)

cbos#set ppp wan0-0 password (your password)

cbos#set ppp restart enabled

cbos#set dhcp server enabled

cbos#set nat enabled

cbos#set web disabled

cbos#set web port 5000

cbos#set int wan0-0 close

cbos#set int wan0-0 vpi 0

cbos#set int wan0-0 vci 32

cbos#set int wan0-0 open

cbos#write

cbos#reboot

Then you will see

     Hello!
     Expanding CBOS image...
     CBOS [version]
      

cbos>enable Password:Hit enter

cbos#set password exec (your password)

cbos#set password enable (your password)

cbos#write

cbos#reboot

[[Category:DSL Troubleshooting|Cisco 678 Single IP]