Using Hyperterminal to Connect to Your Cisco 675/678

From XMission Wiki
Revision as of 06:53, 25 July 2007 by Deadguy (talk | contribs) (New page: Using Hyperterminal to Connect to Your Cisco 675/678 #Connect the serial end (metal) of your management cable to Com port 1 on your computer and the other end (plastic) into the manageme...)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Using Hyperterminal to Connect to Your Cisco 675/678

  1. Connect the serial end (metal) of your management cable to Com port 1 on your computer and the other end (plastic) into the management port of your Cisco router.
  2. Click Start, go to Programs, Accessories, Communications, and select Hyperterminal.
  3. Double-click on Hypertrm.
  4. Enter any name for the connection you'd like and choose an icon.
  5. Click OK.
  6. In the Connect using: field, choose Direct to Com1.
  7. Click OK.
  8. Change the Bits per second: to 38400.
  9. Change the Flow control: to None.
  10. Click OK.
  11. Hit the enter key and you should get a password: prompt.
Note: If you don't get a password: prompt, to check to be sure the management cable is plugged into Com1. Disconnect and reconnect again.
Retrieved from "http://wiki.xmission.com/index.php?title=Using_Hyperterminal_to_Connect_to_Your_Cisco_675/678&oldid=111"