Difference between revisions of "DSL Cisco 67x Password Change"

From XMission Wiki
Jump to: navigation, search
m (cleanup)
m
Line 1: Line 1:
 
Cisco 67x Password Change Instructions
 
Cisco 67x Password Change Instructions
  
You will need connect the management serial cable that came with  your Cisco. It will need to be connected to the ''MGMT'' port on the  back of the Cisco and a serial port on your computer. You will then  need to connect to the Cisco with terminal software (e.g: [[Hyperterminal]],  ZTerm, Minicomm, Telix). The speed the terminal software will  communicate with the Cisco will be either 9600 or 38400, no software  or hardware handshaking.
+
You will need connect the management serial cable that came with  your Cisco. It will need to be connected to the ''MGMT'' port on the  back of the Cisco and a serial port on your computer. You will then  need to connect to the Cisco with terminal software (e.g: [[Hyperterm]],  ZTerm, Minicomm, Telix). The speed the terminal software will  communicate with the Cisco will be either 9600 or 38400, no software  or hardware handshaking.
  
 
#At the <span class="button">Password</span> prompt enter your routers exec password.
 
#At the <span class="button">Password</span> prompt enter your routers exec password.

Revision as of 07:51, 25 July 2007

Cisco 67x Password Change Instructions

You will need connect the management serial cable that came with your Cisco. It will need to be connected to the MGMT port on the back of the Cisco and a serial port on your computer. You will then need to connect to the Cisco with terminal software (e.g: Hyperterm, ZTerm, Minicomm, Telix). The speed the terminal software will communicate with the Cisco will be either 9600 or 38400, no software or hardware handshaking.

  1. At the Password prompt enter your routers exec password.
  2. Type "enable" and press the Enter key.
  3. Enter your enable password.
  4. Type set ppp wan0-0 password followed by a space and then your new password.
  5. Enter write.
  6. Enter reboot.