Difference between revisions of "DSL Cisco 67x Password Change"

From XMission Wiki
Jump to: navigation, search
(Creation)
 
m (cleanup)
Line 1: Line 1:
You will need connect the management serial cable that came with  
+
Cisco 67x Password Change Instructions
your Cisco. It will need to be connected to the ''MGMT'' port on the  
+
 
back of the Cisco and a serial port on your computer. You will then  
+
You will need connect the management serial cable that came with your Cisco. It will need to be connected to the ''MGMT'' port on the back of the Cisco and a serial port on your computer. You will then need to connect to the Cisco with terminal software (e.g: [[Hyperterminal]], ZTerm, Minicomm, Telix). The speed the terminal software will communicate with the Cisco will be either 9600 or 38400, no software or hardware handshaking.
need to connect to the Cisco with terminal software (e.g: [[Hyperterminal]],  
 
ZTerm, Minicomm, Telix). The speed the terminal software will  
 
communicate with the Cisco will be either 9600 or 38400, no software  
 
or hardware handshaking.
 
  
 
#At the <span class="button">Password</span> prompt enter your routers exec password.
 
#At the <span class="button">Password</span> prompt enter your routers exec password.

Revision as of 17:33, 18 July 2007

Cisco 67x Password Change Instructions

You will need connect the management serial cable that came with your Cisco. It will need to be connected to the MGMT port on the back of the Cisco and a serial port on your computer. You will then need to connect to the Cisco with terminal software (e.g: Hyperterminal, ZTerm, Minicomm, Telix). The speed the terminal software will communicate with the Cisco will be either 9600 or 38400, no software or hardware handshaking.

  1. At the Password prompt enter your routers exec password.
  2. Type "enable" and press the Enter key.
  3. Enter your enable password.
  4. Type set ppp wan0-0 password followed by a space and then your new password.
  5. Enter write.
  6. Enter reboot.