DSL Cisco 67x Password Change

From XMission Wiki
Revision as of 23:52, 15 July 2007 by Deadguy (talk | contribs) (Creation)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

You will need connect the management serial cable that came with your Cisco. It will need to be connected to the MGMT port on the back of the Cisco and a serial port on your computer. You will then need to connect to the Cisco with terminal software (e.g: Hyperterminal, ZTerm, Minicomm, Telix). The speed the terminal software will communicate with the Cisco will be either 9600 or 38400, no software or hardware handshaking.

  1. At the Password prompt enter your routers exec password.
  2. Type "enable" and press the Enter key.
  3. Enter your enable password.
  4. Type set ppp wan0-0 password followed by a space and then your new password.
  5. Enter write.
  6. Enter reboot.