Difference between revisions of "Cisco 678 Bridged"
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
| + | {{archived}} | ||
| + | |||
These instructions are intended for advanced users only. These instructions are for putting your DSL modem into bridged mode (When using another device for authentication via PPPoE, such as a single computer, a firewall or other router). Please note, that while we are providing these instructions on how to put your modem into bridged mode, we cannot provide any support for devices plugged into the modem after it's put into bridged mode. Please contact your hardware manufacturer for assistance on setting username/password inside that device. | These instructions are intended for advanced users only. These instructions are for putting your DSL modem into bridged mode (When using another device for authentication via PPPoE, such as a single computer, a firewall or other router). Please note, that while we are providing these instructions on how to put your modem into bridged mode, we cannot provide any support for devices plugged into the modem after it's put into bridged mode. Please contact your hardware manufacturer for assistance on setting username/password inside that device. | ||
| Line 27: | Line 29: | ||
reboot | reboot | ||
| − | [[Category:Troubleshooting | + | [[Category:DSL Troubleshooting|Cisco 678 Bridged]] |
| − | |||
[[Category:DSL]] | [[Category:DSL]] | ||
[[Category:PPPoA]] | [[Category:PPPoA]] | ||
Latest revision as of 12:52, 6 June 2019
These instructions are intended for advanced users only. These instructions are for putting your DSL modem into bridged mode (When using another device for authentication via PPPoE, such as a single computer, a firewall or other router). Please note, that while we are providing these instructions on how to put your modem into bridged mode, we cannot provide any support for devices plugged into the modem after it's put into bridged mode. Please contact your hardware manufacturer for assistance on setting username/password inside that device.
Connect to your modem via the serial cable. The following will wipe your current running configuration.
enter enable mode by typing en and hitting enter. Then type the following commands, hitting enter following each command.
set nvram erase
write
reboot
(wait for modem to reboot before continuing)
set bri rfc en
set int wan0-0 disabled
set int wan0-0 vpi 0
set int wan0-0 vci 32
set int wan0-0 enabled
write
reboot
